i was building a hyper coaster with a cable in lift with block sections, 1 of the block sections was on the of the cable lift but when the train at the top of the hill can go forward because the next section is clear, he just drops down right into the station, crashing into another train, i tryd it again and then rct2 crashed.
what can i do tho prevent that cable lift fail from occurring again?
RCT2 problems
Started by
Witting
, Dec 08 2012 05:20 PM
2 replies to this topic
#1
Posted 08 December 2012 - 05:20 PM
#2
Posted 08 December 2012 - 05:40 PM
You shouldn't have any manual placed block sections near your lift. Try re building the coaster if your still having problems, the train should be able to stop at the top of the lift if its stopped by a block break section.
#3
Posted 12 December 2012 - 01:39 PM
You shouldn't have any manual placed block sections near your lift. Try re building the coaster if your still having problems, the train should be able to stop at the top of the lift if its stopped by a block break section.
but what about the station then?