Automatic Holding break
#1
Posted 06 August 2009 - 11:41 PM
well hears the Tut for it
First you will start out with one blue conector on the top rod and none on the bottom
next is the switch
This dose require you to break a rod you could do this with a hack saw or, if you happen to have a rod this length already broken this length you could use that if it is a little bit different in length don't worry it will still work.
this is the length
Trouble Shooting:
If the connectors are falling off the cut rod try hot gluing the 90* connector to the cut rod.
If the car comes too fast and misses the break rod, try moving the yellow gear back and forth until you get it to work or, try a longer rode for the break rod.
If you have any other questions feel free to P.M me or to post them hear and I will add them hear....
Comment
[SIGPIC][/SIGPIC]
92% of teens have moved on to rap. If you are part of the 8% that still listen to real music copy and paste this into your sig.
#2
Posted 07 August 2009 - 11:27 AM
#3
Posted 07 August 2009 - 04:47 PM
[SIGPIC][/SIGPIC]
92% of teens have moved on to rap. If you are part of the 8% that still listen to real music copy and paste this into your sig.
#4
Posted 07 August 2009 - 09:17 PM
Your rotating arm that shuts off the motor is a whole lot better than mine, I can never get it to hit the switch that low and work.
One thing I try not to do is make a rod have to turn with a connecor on the end, it causes a lot of unnecessary friction. I would suggest changing this:
Valleyfair Recres:..........My Tutorials:......
................Steel Venom................Automatic Station Gates.......
..........Corkscrew...................Automatic Drill Launch....
...Round About................Auto on/off switch..
#5
Posted 08 August 2009 - 07:58 AM
[SIGPIC][/SIGPIC]
^Thanks Steel^
1) Leviathan 2) Behemoth 3) Vortex 4) Sheikra 5) Kumba 6) Kraken 7) Montu 8) Manta 9) Dragon Fire 10) Gwazi
#6
Posted 08 August 2009 - 12:01 PM
#7
Posted 09 August 2009 - 12:01 PM
Oh, and it's brake, not break.
#8
Posted 03 October 2009 - 08:20 PM