105 replies to this topic

[griffon14]

I think i'm gonna raise it by one grey.















Please comment, I've never built an invert before so any help is appritiated.

[dylan]

Yeah i have one thing you could fix. Push the middle of the drop down a little and then it would be the best drop possible. I like it otherwise, MOVE ON!!!!

[Kraken]

Woohoo, another project by Sferico! I like it, except it could do without that straight spot after the lift...

[dylan]

Woohoo, another project by Sferico! I like it, except it could do without that straight spot after the lift...

The straight part is fine!!!!

[griffon14]

Umm, all B&M's have a prelift.

^^^thanks, i think i see what you mean.

More comments?

[dylan]

Ok good. I just realized that you have about 30 connections on that drop. Thats great for this type of coaster. DEFFINENTLY MOVE ON!!!!!

[DDRman732865]

What omgwtfetc. meant was the straight part after the predrop. It's fine, just leave it. The drop looks great, lots of connections with green 135* connectors.

[griffon14]

Well, I finished sorting my pieces and found out i need to buy bigger containers.

I think i'm going to raise it by one and a half greys and do a drop like on alpengiest. Tell me what you guys think!!!

[Rollerboaster]

I think that would be awesome. Looking forward to it

[griffon14]

well, i've missed three days on school because of snow so i got alot done. i think the drop is good but i think the zero-g needs some work so i need some help with that.















Heres the problem area.

[mynci321]

Looks good, but you should stretch out the 0-g more and make it enter/exit less steeply.

[the_burrito_master]

^ agreed. that would prolly fix your issue.

Also try raising the middle of the roll a little

[rollercoasterfanatic919]

Looks pretty good, I like it. My only suggestion is to make the pullout a bit smaller, it looks pretty big, and it would give you more space.

[maarten12]

I would do what the others said. And fix this spot too



Good luck with fixing the zero-g!

[Eggo]

On the left side there's a crosstie not in the tubing.. It looks great!

[maarten12]

^ cmon, that's exactly the same I said. Or did you post it while you haven't seen mine yet?

[griffon14]

Lol. Thanks guys, I'll Try to get some work done tommorrow but I won't be updating for a while. this next week for me is going to be packed as hell.

oh and rcf919, no one complained when steel's pullout was big so I think it's fine. plus I really like watching the cars swoop down through the pull out.

Thanks for all the comments, keep em' comming.

[Millcreek47]

Haha, that crosstie might pose as a problem...MAKAK will fix it!...ummm yeah, looks nice. I like the big pull out.

What's next? Immelmann then loop?

[griffon14]

Dive loop so it's parrellel to the wall. I don't no if i'll have the height for a loop though. I think I'll just do a bad ass twister section with at least two corks.

^ I appritiate your input Makak. (not the best makak joke).

[Millcreek47]

Haha, I get it...I don't like dive loops...Immelmanns are better.